All Articles

How to connect lithium -ion battery packets and connect balanced charging 1. Diode isolation parallel charging balance method Take 6 single batteries as an example, disconnect the switch S1S5 and then connect the charging power. The diode is selected from 1N54015408, 3A rated current measured the positive pressure drop of the diode to 0.8V, and the current flowing over the diode when the forward voltage drops 0.7V is small. The maximum charging voltage of lithium iron phosphate has a maximum charging voltage

1. How to charge the new battery In the use of lithium-ion batteries, it should be noted that the battery will enter the sleep state after being placed for a period of time. At this time, the capacity is lower than the normal value, and the use time will also be shortened. However, lithium-ion batteries are easy to activate. They can be activated after 3-5 normal charge-discharge cycles to restore normal capacity. Because of the characteristics of lithium-ion battery itself, it has almost no memory effect. As

Theoretically, the capacity of lithium-sulfur battery is five times that of the current battery electrode, and the voltage is about 2.123V. Although these characteristics of lithium-sulfur batteries are very prominent, the recyclability of lithium-sulfur batteries is very low. After 50 charging cycles, the capacity density of the lithium-sulfur battery drops rapidly, which is mainly due to the dissolution and volume expansion of Li2Sn (4≤ n≤ 8) as a medium and the low conductivity of sulfide and polysulfid

Storage environment of lithium ion battery electrolyte The electrolyte of commercialized lithium hexafluorophosphate shall not exceed 60 ℃. If the solvent also contains dimethyl carbonate, diethyl carbonate and other solvents with lower boiling points, high temperature is not recommended. Electrolyte solvent is generally mixed solvent. It is better to be at - 10~40 ℃. Storage and use method of lithium ion battery electrolyte The electrolyte of lithium ion battery is an important part of the battery, which

Working principle of dry battery The dry battery belongs to the primary battery in the chemical power supply. It is a disposable battery. Its carbon rod is used as the positive pole, and the zinc cylinder is used as the negative pole. It converts chemical energy into electrical energy to supply the external circuit. In the chemical reaction, because zinc is more active than manganese, zinc loses electrons and is oxidized, and manganese gains electrons and is reduced. Dry batteries are not only suitable for flash

Analyze the comparative test of power lithium-ion battery at home and abroad According to the GB/T31484GB/T31485GB/T31486 test standard, the battery samples of different materials and different packaging forms (soft package, square hard shell and cylindrical winding) at home and abroad were selected for benchmarking analysis, including 4 domestic lithium iron phosphate batteries, 3 ternary materials batteries, 1 lithium manganate battery, and 2 Japanese and Korean ternary materials batteries. The test objects ar

There are more and more shortcomings exposed by simple mechanical assembly methods, and cannot meet the requirements of continuous improvement of power lithium batteries. The adhesive assembly or assembly is made up for the lack of mechanical assembly. The types of adhesives used in power lithium batteries include structural adhesives, heat conductive adhesives, solder joint protection glue and sealing, and so on. Adhesives are used to improve the performance and safety of power lithium batteries and use them in mu

1 Application scenario of large -scale energy storage system New energy power stations, wind power or solar power stations, in order to achieve the purpose of flat -input power fluctuations, more and more power plants have begun to equip energy storage systems. Independent energy storage power stations have gradually entered people's vision with the reform of the power system, and independent energy storage power stations that live up to sell electricity have gradually appeared. Micro grids contain a s

The biggest difference between new energy vehicles and traditional cars is to use batteries as power -driven, so the technology of power lithium batteries is the core of new energy vehicles. What is the core technology of BMS? Recently, I saw a propaganda sign of a domestic company. Because of the underlying software such as the software architecture of AutoSAR, it claimed to fully master BMS software and hardware technology, reached the world's advanced level, and adopted multiple equilibrium control cap